English Manual: Super Power Series 60-80 25/03/2004
6
10 CONTROL PANEL AND THRUSTER CONTROL BOX FUNCTIONS
To switch the thruster "ON" or "OFF" follow the instructions on the diagrams below.
When switched "ON" the unit will beep once and the green LED in the red push-button
will light up.
When switched "OFF" the unit will beep twice and the green LED in the red push-button
will go out.
The thruster controller provides a time delay between left and right thrust in order to avoid
rapid direction changes, but no delay when thrusting to same side.
If the thruster motor overheats the unit will start beeping, while the green LED will flash, until
the thruster motor has cooled down.
Once the overheat alarm starts, one has 10 seconds of actual thruster use before the unit
automatically shuts down. The unit will then not be able to be switched on again until the
motor has cooled down.
If the thruster unit has not been used for a period of thirty minutes the unit will automatically
switch off. Before switching off automatically the unit will warn you by beeping
once followed by a second beep a few seconds later, after which the unit switches off.
In order to isolate the power circuit of the thruster motor as described in the two points
above one would need to install an electric battery isolator, as advised by Max Power
( see
"Wiring Diagram" in the back of this manual for more detail ).
POWER
POWER
POWER
Single Touch Panel:
Single Joystick Panel:
Double Joystick Panel:
Green
Push-button
Joystick
Joystick
Joystick
To Switch "ON" or "OFF"
push down both red &
green push-button for one
second.
To Switch "ON" or "OFF"
push down the red push-
button, while pushing
joystick to the right for
one second.
To Switch "ON" or "OFF"
push down the red push-
button, while pushing
joystick to the right for
one second, for both bow
and stern thruster.
Red Push-button
with Green LED
Red Push-button
with Green LED
Red Push-button
with Green LED
Red Push-button
with Green LED
11 CONTROL PANEL INSTALATION
Control panels should be protected from the natural elements while the thruster is not in use.
Install the control panel(s) in easily accessible positions, without obstructing the main engine
and/or steering controls.
When fixing the panel with the black stainless steel screws, make sure to install the pre-cut
rubber seal, as supplied with the panel, ensuring that it is in the correct place.
IMPORTANT: Only when totally finished and satisfied with wiring and positioning of the unit,
clip-on the face panel/cover.
Please note that panels are only fully waterproof from the front, if installed correctly. However
the area behind the dashboard should be kept dry to avoid the risk of oxidation of the cable
connecter contacts.
For full installation instructions of the control panels please refer to “Installation Guidelines “
as supplied with each control panel.
(19 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern